1. #1
    Unregistered

    Getting "Verifying DMI Pool Data" error while trying to Install windows 8 by mounting the Image as Virtual Drive

    Currently I use windows 7 ultimate 64-bit edition.I was trying to install windows 8 in my system so I Mounted the windows 8 Image as Virtual Drive. When I started the Installation process, It displays an error “Getting "Verifying DMI Pool Data". What is this error?



  2. #2
    supermaster Array
    Join Date
    Jun 2012
    Posts
    349

    Re: Getting "Verifying DMI Pool Data" error while trying to Install windows 8 by mounting the Image as Virtual Drive

    My dear friend,
    this message is displayed When the computer is running the power-on self test (POST).
    this problem is cause by defective or non-compatible hardware.
    TO solve this problem you have to contact your computer manufacturer.

  3. #3
    raj_tiwary007 Array
    Join Date
    Oct 2012
    Posts
    86

    Re: Getting "Verifying DMI Pool Data" error while trying to Install windows 8 by mounting the Image as Virtual Drive

    Dear

    Verifying DMI Pool Data error solution is as follows:

    Suggestions to Resolve the Condition:

    1. Apply power to the computer.
    2. Access the system BIOS.
    * Set the drive type as None or Not Installed.
    * Load BIOS Defaults
    * Load SETUP Defaults
    3. Save the BIOS changes and reboot the PC to a System Boot Diskette.
    4. Shut down the PC after the memory count is displayed.
    5. Reconnect the power and interface cables to the hard drive.
    6. Access the System BIOS.
    7. Auto-Detect the hard drive. Ensure that the LBA Mode option is enabled.
    8. Save the BIOS changes and boot the PC with a System Diskette.
    9. Partition and format the hard drive via the operating system.
    10. Reboot the system. On bootup, the screen should read:
    Verifying DMI Pool Data
    Update Successful

    The system should continue booting normally.

+ Reply to Thread

Similar Threads

  1. Replies: 9
    Last Post: 25-08-2013, 07:59 PM
  2. Replies: 26
    Last Post: 11-08-2013, 10:23 PM
  3. Replies: 12
    Last Post: 18-05-2013, 09:11 AM
  4. What is "Error 1079" after starting remote registry service?
    By Unregistered in forum Windows Forum
    Replies: 3
    Last Post: 16-10-2012, 12:34 AM
  5. Replies: 11
    Last Post: 31-08-2012, 10:01 PM